DTC P0110, DTC P0112 Or DTC P0113: Notes
WARNING: This page is about a different car, the 2003 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
Code Definition
- DTC P0110: Intake Air Temperature Sensor Circuit
- DTC P0112: Intake Air Temperature Sensor Circuit Low Input
- DTC P0113: Intake Air Temperature Sensor Circuit High Input
CAUTION:
If Engine Control Module (ECM) replacement is instructed in following test, always ensure ECM electrical connectors and ground circuits are okay. If either are defective, repair and repeat testing to confirm ECM malfunction. On models equipped with engine immobilizer, if ECM is replaced, ECM must be programmed with proper ignition key code for engine immobilizer system. For programming procedures, see COMPUTER RELEARN PROCEDURES - TOYOTA
article in GENERAL INFORMATION, or appropriate ENGINE IMMOBILIZER SYSTEMS article in ACCESSORIES & EQUIPMENT.
NOTE:
If DTCs related to IAT sensor, HO2S, TP control motor and sensor, ECT sensor and VP sensor are output simultaneously, the E2 sensor ground circuit at terminal No. 28 (Brown/White wire) at ECM connector E5 may be open. See ENGINE PERFORMANCE in SYSTEM WIRING DIAGRAMS article in ELECTRICAL. For ECM electrical connector terminal identification, see Figure. It may be necessary to check Brown/White wire between splice E10 and terminal No. 28 at ECM connector E5. See Fig 1.