Shift Lever And Control Cable: Installation
WARNING: This page is about a different car, the 2004 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
Installation is in the reverse order of removal (See REMOVAL ).
NOTE:
When installing the 2 control cables, you must observe the following items.
- When handling the cable, do not bend the cable less than R130°.
- Pay thorough attention not to damage the boots.
- When installing, do not apply force but install it gently.
- After finishing the installation, check the cable for twist. If there is any irregularity, adjust it.
- Never reuse the board-type clip to fix the control cable.