Section 554 (Back Door Control System - Diagnostics): Pre-Check
WARNING: This page is about a different car, the 2003 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.
- DATA LIST NOTE: According to the DATA LIST displayed by the hand-held tester, you can read the value of the switch, sensor, actuator and so on without parts removal. Reading the DATA LIST as a first step of troubleshooting is one of the method to shorten the labor time.
- Connect the hand-held tester to the DLC3.
- Turn the ignition switch ON.
- According to the display on tester, read the "DATA LIST".
- ACTIVE TEST NOTE: Performing the ACTIVE TEST using the hand-held tester allows the relay, VSV, actuator and so on to operate without parts removal. Performing the ACTIVE TEST as a first step of troubleshooting is one of the method to shorten the labor time.
It is possible to display the DATA LIST during the ACTIVE TEST.
- Connect the hand-held tester to the DLC3.
- Turn the ignition switch ON.
- According to the display on tester, perform the "ACTIVE TEST".
ACTIVE TESTItem Test details Diagnostic Note DOOR LOCK Drive The Door Lock Motor At Rear Door LOCK/UNLOCK - P/W UP/DOWN Drive The P/W Motor UP/DOWN During This ACTIVE TEST, Jam Protection Caught Detection Can Be Monitored. (Refer To The DATA LIST For Details)