LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2004 >> Matrix Base, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 695 (Lighting System - Diagnostics) >> Operation Check
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Operation Check

WARNING: This page is about a different car, the 2004 Toyota Camry Solara. However, it is still accessible from the selected car via links, so may be relevant.
  1. ILLUMINATED ENTRY SYSTEM OPERATION CHECK 
    1. Illuminated entry system controls the following lamps:
      • Ignition key cylinder light (Transponder key amplifier)
      • Interior light (Room lamp assy No.1)
      • Map lamp assy (convertible only)
    2. Check that the lamps come on after:
      1. Unlocking any door that was closed and locked with the ignition switch off
    3. Check that the lamps fade out after:
      1. Leaving the doors unlocked for 15 seconds
      2. Turning the ignition switch to the ACC or ON position
      3. Locking all the doors
    4. Check that the lamps stay ON for at least 15 seconds after opening any of the doors, then fade out again after 15 seconds.
    5. Check that the lamps come on after:
      1. Closing all the doors and turning the ignition switch from the ACC or ON position off.
    6. Check that the lamps fade out after:
      1. Leaving the doors unlocked for 15 seconds
      2. Locking all the doors
    7. Check that the lamps stay ON for at least 15 seconds after opening any of the doors, then fade out again in 15 seconds after closing all the doors.
    8. Check that the lamps come on when opening any of the doors and fade out after either closing and locking them or turning the ignition switch to the ACC or ON position.
  2. BATTERY SAVER OPERATION CHECK 
    1. Remove the ignition key and close all doors.
    2. Open any door to turn the room light on, and leave it open. Check that the light goes off in approximately 20 minutes.
    3. After the room light goes off, close the driver's door.
    4. Open any door to turn the room light on, and then open another door. Check that the room light goes off within 20 minutes after opening the doors.
    5. Close all doors. With the ignition key inserted, open any door to turn the room light on, and then remove the ignition key. Check that the room light goes off within 20 minutes.
  3. LIGHT AUTO TURN OFF OPERATION CHECK 
    1. Turn the ignition switch to the ON position, and switch the headlamps into the TAIL or HEAD position.
    2. Turn the ignition switch off and open the driver's door, and check that the headlamps go off after approximately 30 seconds.
    3. Turn the ignition switch to the ON position, and switch the headlamps to the TAIL or HEAD position.
    4. Turn the ignition switch off and open the driver's door. Before the headlamps go off after approximately 30 seconds, lock all doors. Check that the headlamps go off immediately.
  4. AUTOMATIC LIGHT CONTROL OPERATION CHECK 
    1. Turn the ignition switch to the ON position.
    2. Turn the headlamp dimmer switch to the AUTO position.
    3. Cover the automatic light control sensor and check that the tail lamp and headlamp in order.
    4. Uncover the automatic light control sensor and check that the headlamp and tail lamp go off in order.
  5. DAYTIME RUNNING LIGHT OPERATION CHECK 
    1. Check that the high beams come on when the headlamp switch is off with the engine running and parking brake released.
    2. Check that the high beams go off when turning the headlamp dimmer switch into the TAIL or HEAD (LOW) position under the condition as shown in  a.
    3. Check that the high beams go off when turning the ignition switch off under the condition as shown in  a.
scientia non olet · About LEMON Manuals