How To Proceed With Troubleshooting

HINT:

The wireless door lock control system troubleshooting procedures are based on the premise that the power door lock system is operating normally. Check the power door lock system first before troubleshooting the wireless door lock control system.

Use this procedure to troubleshoot the wireless door lock control system.

The hand-held tester should be used in step 3.

1. VEHICLE BROUGHT TO WORKSHOP 
   1. Go to next step 
2. CUSTOMER PROBLEM ANALYSIS CHECK AND SYMPTOM CHECK (See  CUSTOMER PROBLEM ANALYSIS CHECK  ) 
   1. Go to next step 
3. CHECK FOR DTCS 
   1. Check for DTCs and note any codes that are output.
   2. Delete the DTC.
   3. Recheck for DTCs. Try to prompt the DTC by simulating the original activity that the DTC suggested.
      1. If the DTC does not reoccur, proceed to A.
      2. If the DTC reoccurs, proceed to B.
   1. B: Go to step   6 
   2. A: Go to next step 
4. PROBLEM SYMPTOMS TABLE (See  PROBLEM SYMPTOMS TABLE  ) 
   1. If the fault is not listed on the problem symptoms table, proceed to A.
   2. If the fault is listed on the problem symptoms table, proceed to B.
   1. B: Go to step   3 
   2. A: Go to next step 
5. OVERALL ANALYSIS AND TROUBLESHOOTING 
   1. Terminals of ECU (see TERMINALS OF ECU )
   2. On-vehicle inspection (see ON-VEHICLE INSPECTION )
   1. Go to next step 
6. ADJUST, REPAIR OR REPLACE 
   1. Go to next step 
7. CONFIRMATION TEST 
   1. Go to next step 
   2. END