LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2004 >> Matrix Base, 4WD >> Repair and Diagnosis >> External Pages >> Different car >> Section 948 (Power Liftgate System) >> Liftgate Drive Unit Motor >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Liftgate Drive Unit Motor: Removal

WARNING: This page is about a different car, the 2004 Chrysler Pacifica. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the liftgate.
  2. Disconnect and isolate the negative battery cable.
  3. Remove the left rear D-pillar trim panel from the vehicle. Refer to D-PILLAR TRIM .
  4. Remove the power liftgate drive unit assembly from the vehicle. Refer to REMOVAL .
  5. Disconnect the wire harness connector from the motor assembly. Gently pry the retaining tabs apart until the connector comes free from the motor.
    Fig 1: Removing Power Liftgate Motor Retaining Screws
    G03572375Courtesy of DAIMLERCHRYSLER CORP.
  6. Remove the three T25 motor retaining screws (Fig 1) and remove the motor from the drive unit.
scientia non olet · About LEMON Manuals