Torque Specification: 1ZZ-FE/2ZZ-GE:
TORQUE SPECIFICATION
| Part Tightened | N.m | kgf.cm | ft.lbf |
|---|---|---|---|
| Lead wire to Terminal C | 10 | 102 | 7 |
| Starter assy to Transaxle housing assy | 37 | 378 | 27 |
| Starter wire to Starter assy | 9.8 | 100 | 7 |
| Battery negative terminal to Battery | 5.4 | 55 | 48 in.lbf |
| Starter commutator end frame assy to Starter drive housing assy | 6.0 | 61 | 53 in.lbf |
| Repair service starter kit to Starter drive housing assy | 7.5 | 76 | 66 in.lbf |
| Generator assy to Engine mounting bracket RH | 25 | 250 | 18 |
| Generator assy to Timing chain cover sub-assy 1ZZ-FE | 54 | 550 | 40 |
| Generator assy to Timing chain cover sub-assy 2ZZ-GE | 58 | 590 | 43 |
| Wire harness clamp bracket to Engine mounting bracket RH (2ZZ-GE) | 5.4 | 55 | 48 in.lbf |
| Generator wire to Generator assy | 9.8 | 100 | 7 |
| Generator bracket No. 1 to Generator assy (2ZZ-GE) | 29 | 296 | 21 |
| Generator bracket No. 1 to Intake air surge tank (2ZZ-GE) | 29 | 296 | 21 |
| Air pump outlet pipe to Body | 7.0 | 71 | 62 in.lbf |
| Retainer plate to Generator drive end frame (2ZZ-GE) | 3.0 | 31 | 27 in.lbf |
| Generator rectifier end frame to Generator drive end frame | 4.5 | 46 | 40 in.lbf |
| Generator cord clip to Generator drive end frame | 5.4 | 55 | 48 in.lbf |
| Generator w/ rectifier holder to Generator drive end frame | 2.9 | 30 | 26 in.lbf |
| Generator regulator assy to Generator rectifier end frame | 2.0 | 20 | 18 in.lbf |
| Generator brush holder assy to Generator rectifier end frame | 2.0 | 20 | 18 in.lbf |
| Generator rear end cover to Generator rectifier end frame | 4.4 | 45 | 39 in.lbf |
| Terminal plate to Generator rectifier end frame Bolt | 3.9 | 30 | 35 in.lbf |
| Terminal plate to Generator rectifier end frame Nut | 4.4 | 45 | 39 in.lbf |