Inspection Procedure

CHECK DOOR LOCK (See appropriate door lock under INSPECTION ).
1. NG: REPLACE DOOR LOCK
2. OK: Go to next step.

CHECK WIRE HARNESS (TVIP ECU <--> DOOR LOCK)

Disconnect the TVIP ECU and door lock connectors.
Check the continuity between the terminals of the TVIP ECU connector and door lock connector, as shown in the Fig 1 and TERMINAL CONTINUITY SPECIFICATIONS .

Standard:

Fig 1: Identifying TVIP Connector T3 Terminals LSWD(37), LSWP(38), Connectors D11, & D12 Terminals

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

TESTING DOOR LOCK CONTINUITY

Test Between Terminals No.	Specified Condition
LSWD (T3-37) <--> D11-8	Continuity
LSWP (T3-38) <--> D12-7	Continuity

CHECK WIRE HARNESS (DOOR LOCK <--> BODY GROUND)

Disconnect the door lock connector.
Check the continuity between the terminal of the door lock connector and body ground, as shown in Fig 2 and TESTING DOOR LOCK CONTINUITY .

Standard:

Fig 2: Identifying Door Lock Connector Terminals

TESTING DOOR LOCK CONTINUITY

Test Between Terminals No.	Specified Condition
D11-7 <--> Body Ground	Continuity
D12-8 <--> Body Ground	Continuity

NG: REPAIR OR REPLACE WIRE HARNESS AND CONNECTOR
OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN ON PROBLEM SYMPTOMS TABLE. (See PROBLEM SYMPTOMS TABLE ).