Data List/Active Test
- DATA LIST
- Warm up the engine.
- Turn the ignition switch OFF.
- Connect the hand-held tester or the OBD II scan tool to the DLC3.
- Turn the ignition switch ON.
- Push the "ON" button of the hand-held tester or the OBD II scan tool.
- Select the item "DIAGNOSIS / ENHANCED OBD II / DATA LIST."
- According to the display on the tester, read the "DATA LIST."
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
- ACTIVE TEST
It is possible to display the DATA LIST during the ACTIVE TEST.
- Warm up the engine.
- Turn the ignition switch OFF.
- Connect the hand-held tester or the OBD II scan tool to the DLC3.
- Turn the ignition switch ON.
- Push the "ON" button of the hand-held tester or the OBD II scan tool.
- Select the item "DIAGNOSIS / ENHANCED OBD II / ACTIVE TEST."
- According to the display on the tester, perform the "ACTIVE TEST."
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
NOTE:
Using the DATA LIST displayed by the hand-held tester or the OBD II scan tool, you can read the value of the switches, sensors, actuators and so on without parts removal. Reading the DATA LIST as a first step of troubleshooting is one method to shorten diagnostic time.
NOTE:
The values given below for "Normal Condition" are representative values. A vehicle may still be normal even if its value differs from those listed here. Do not solely depend on the normal condition here when deciding whether a part is faulty or not.
NOTE:
Performing the ACTIVE TEST using the hand-held tester or the OBD II scan tool allows the relay, VSV, actuator and so on to operate without parts removal. Performing the ACTIVE TEST as a first step of troubleshooting is one method to shorten diagnostic time.