DTC P0110, DTC P0112 & DTC P0113: Notes
WARNING: This page is about a different car, the 2003 Toyota Tundra. However, it is still accessible from the selected car via links, so may be relevant.
Code Definition
- DTC P0110: Intake Air Temperature Sensor Circuit
- DTC P0112: Intake Air Temperature Sensor Circuit Low Input
- DTC P0113: Intake Air Temperature Sensor Circuit High Input
CAUTION:
If Engine Control Module (ECM) replacement is instructed in following test, always ensure ECM electrical connectors and ground circuits are okay. If either are defective, repair and repeat testing to confirm ECM malfunction.
NOTE:
If DTCs related to TPS, IAT sensor, MAF meter, ECT sensor, APP sensor & VPS are output simultaneously, the E2 sensor ground circuit at ECM 31-pin connector E7 terminal No. 11 (Black/White wire) may be open. For ECM electrical connector terminal identification, see Figure. It may be necessary to check Black/White wire between splice I13 and ECM 31-pin connector E7 terminal No. 11. Splice I13 is located behind passenger's side of instrument panel. See Figure.