Possible Causes
WARNING: This page is about a different car, the 2003 Toyota Tundra. However, it is still accessible from the selected car via links, so may be relevant.
DTC P0335 is set when ECM does not receive input signal from crankshaft position sensor with engine cranking or with engine speed 600 RPM or more. DTC P0339 is set when ECM does not receive input signal from crankshaft position sensor with engine speed of 1000 RPM or more. Possible causes are:
- Crankshaft position sensor circuit is open or shorted.
- Defective crankshaft position sensor.
- Defective signal plate on crankshaft sprocket.
- Defective ECM.