Possible Causes
WARNING: This page is about a different car, the 2003 Toyota 4Runner. However, it is still accessible from the selected car via links, so may be relevant.
DTC P0335 is set when ECM does not receive input signal from crankshaft position sensor with engine cranking or with engine speed 600 RPM or more (2 trip detection logic). DTC P0339 is set when no crankshaft position sensor (NE) signal is input for 0.05 second or more with engine speed of 1000 RPM or more, STA signal is OFF and 3 seconds or more has lapsed after STA signal is switched from ON to OFF. Possible causes are:
- Crankshaft position sensor circuit is open or shorted.
- Defective crankshaft position sensor.
- Defective signal plate on crankshaft sprocket.
- Defective ECM.