Assembly (90-Amp)
WARNING: This page is about a different car, the 2004 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
Place drive end frame on pulley and install rotor in drive end frame. Place generator washer on rotor and position rectifier end frame on rotor. Using 29 mm socket, slowly press in rectifier end frame. Use generator Pulley Set Nut Wrench Set (SST 09820-63011) to install generator pulley. Place SST "C" securely into a vise. Install SST "A" and "B" and generator into SST "C". See Figure. Tighten pulley nut in the opposite direction of disassembly. See TORQUE SPECIFICATIONS . To complete reassembly, reverse disassembly procedure. After completing assembly, verify rotor turns smoothly.