Inspect Wireless Door Lock Transmitter Operation
WARNING: This page is about a different car, the 2002 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Refer to REPLACE TRANSMITTER (LITHIUM) BATTERY .
- Using a screwdriver, remove the cover.
- Remove the battery (lithium battery).
- Install a new or normal battery (lithium battery).
- The minimum operation distance differs according to operator, the way the transmitter is held, and location.
- As weak wave is used, operation distance might be shortened when noise is detected in strong wave or used frequency.
- Approximately 1 meter away from driver's outside handle, check the transmitter operation when pressing transmission switch on the side of the transmitter body.
Standard : Remote control of vehicle door lock can be operated.
- Install the battery (lithium battery).
- Install a cover so that rubber cover is not distorted or slipped off.
NOTE:
When a new or normal battery can not be obtained, connect 2 new 1.5 V batteries in series, connect the battery (+) to the battery receptacle side terminal and battery (-) to the bottom terminal, then apply 3 volts to the transmitter.
NOTE: