LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2004 >> Matrix Base, FWD, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 489 (Combination Meter) >> Adjustment >> Reset Inclination Sensor Inside Combination Meter
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Reset Inclination Sensor Inside Combination Meter

WARNING: This page is about a different car, the 2004 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
  1. After replacing the part, install the combination meter to the vehicle.
  2. Move the vehicle to a flat area that has a surface with an angle of inclination no greater than +/- 0.5°.
  3. With the ignition switch in the OFF position, press the trip switch.
  4. While pressing the trip switch, turn the ignition switch to the ON position.
  5. Within 5 seconds after the ignition switch is turned ON, release the trip switch and press the trip switch 3 times. On the third press, hold the switch for 5 seconds. An 800 Hz buzzer will sound for 1 second.
  6. After the buzzer stops, release the trip switch.
  7. After the buzzer stops, press the trip switch one more time and hold it for 5 seconds. Again, an 800 Hz buzzer will sound for 1 second.
  8. The horizontal setting is now complete.

    HINT:

    If, in step  g, a buzzer higher than that of step  e (for example, 1.9 kHz) sounds continually, turn the ignition switch to the OFF position and perform the procedures from step  c again.

scientia non olet · About LEMON Manuals