Inspection Procedure

WARNING: This page is about a different car, the 2003 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.

Check DVD player.
PREPARATION:

Remove the DVD player with connector still connected.

CHECK:
1. Check that the output waveform of terminal CDR+ and SGND when DVD sounding.
2. Check that the output waveform of terminal CDR- and SGND when DVD sounding.
3. Check that the output waveform of terminal CDL+ and SGND when DVD sounding.
4. Check that the output waveform of terminal CDL- and SGND when DVD sounding.
OK:
1. A waveform synchronized with sounds is output.
1. NG : Replace DVD player.
2. OK : Go To Next Step.
Check wire harness.
PREPARATION:

Disconnect the connector DVD player and RSE ECU.

CHECK:
1. Check continuity of the wire harness between terminal CDR+ of the rear display and terminal VTR+ of the RSE ECU.
2. Check continuity of the wire harness between terminal CDR- of the rear display and terminal VTR- of the RSE ECU.
3. Check continuity of the wire harness between terminal CDL+ of the rear display and terminal VTL+ of the RSE ECU.
4. Check continuity of the wire harness between terminal CDL+ of the rear display and terminal VTL+ of the RSE ECU.
5. Check continuity of the wire harness between terminal SLD of the rear display and terminal SG4 of the RSE ECU.
OK:
1. Continuity
1. NG : Repair or replace harness and connector.
2. OK : Replace RSE ECU.