Inspection Procedure
WARNING: This page is about a different car, the 2004 Toyota Camry. However, it is still accessible from the selected car via links, so may be relevant.
- INSPECT FRONT DOOR COURTESY LAMP SWITCH ASSY
- Inspect front door courtesy lamp switch continuity.
- Check that there is continuity between terminal 1 and body ground when switch is operated.
Standard:
ON (When shaft is pressed): No continuity
OFF (When shaft is not pressed): Continuity
- NG: REPLACE FRONT DOOR COURTESY LAMP SWITCH ASSY (DRIVER SIDE DOOR)
- OK: Go to next step.
- Inspect front door courtesy lamp switch continuity.
- INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSY (ACC)
- Measure voltage between terminal 2A-7 (ACC) of instrument panel J/B assy and body ground.
Standard:
SPECIFIED CONDITIONIG switch Tester connection Specified condition ACC 2A-7 (ACC) - Body ground 10 - 14 V OFF 2A-7 (ACC) - Body ground Below 1 V
- NG: REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER SOURCE)
- OK: CHECK AND REPLACE INSTRUMENT PANEL JUNCTION BLOCK ASSY
- Measure voltage between terminal 2A-7 (ACC) of instrument panel J/B assy and body ground.