How To Proceed With Troubleshooting

WARNING: This page is about a different car, the 2004 Toyota Camry Solara. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

The hand-held tester can be used at step 3, 6, 9, 12.

Vehicle Brought to Workshop
1. Go To Next Step
Customer Problem Analysis (SEE CUSTOMER PROBLEM ANALYSIS CHECK )
1. Go To Next Step
Check and Clear DTCs and Freeze Frame Data (SEE DATA LIST/ACTIVE TEST )
1. Go To Next Step
Problem Symptom Confirmation
1. Symptom does not occur: Go to step 5
2. Symptom occurs: Go to step 6
Symptom Simulation (SEE ELECTRONIC CIRCUIT INSPECTION PROCEDURE )
1. Go To Next Step
DTC Check (SEE FREEZE FRAME DATA OF ABS )
1. There is no output: Go to step 7
2. There is output: Go to step 8
Problem Symptoms Table (SEE DIAGNOSIS SYSTEM )
1. Check for fluid leakage and Go to step 10
DTC Table (SEE DTC C0200/31 RIGHT FRONT SPEED SENSOR, DTC C0205/32 LEFT FRONT SPEED SENSOR, DTC C1330/35 RIGHT FRONT SPEED SENSOR CIRCUIT, DTC C1331/36 LEFT FRONT SPEED SENSOR CIRCUIT )
1. Go To Next Step
Circuit Inspection (SEE - INSPECTION PROCEDURE )
HINT:

When 2 or more DTCs are detected, perform circuit inspection one by one until the problem is identified.
1. Go To Next Step
Identification of Problem
1. Go To Next Step
Repair
1. Go To Next Step
Confirmation Test
1. End