Section 697 (Power Window Control System (Coupe) - Diagnostics): Initialization
WARNING: This page is about a different car, the 2004 Toyota Camry Solara. However, it is still accessible from the selected car via links, so may be relevant.
- RESET (INITIALIZE) POWER WINDOW REGULATOR MOTOR (DRIVER SIDE) NOTE:
- Resetting the power window regulator motor (initializing the pulse sensor) is necessary if: 1) the battery terminal is disconnected; 2) the power window regulator master switch, wire harness, power window regulator switch, power window regulator and power window regulator motor are replaced or removed/installed; or 3) the PWR fuse, P/W fuse and ECU-IG fuse are replaced. If resetting is not performed, the master switch will not be able to operate the AUTO operation function, jam protection function and remote operation function.
- Whenever disconnecting the battery terminal, reset all the other systems besides the power window control system (see PRECAUTION ).
- Turn the ignition switch ON.
- Halfway open the power window by pressing the power window switch.
- Fully pull up the switch until the power window is fully closed and continue to hold the switch for at least 1 second after the power window is fully closed.
- Check that the AUTO UP/DOWN function operates normally.
If the AUTO UP/DOWN function operates normally, reset operations are complete. If abnormal, follow steps (e) to (g) below.
- Disconnect the negative battery terminal for 10 seconds.
- Connect the battery terminal.
- Perform steps a to d again.