Diagnosis & Repair
WARNING: This page is about a different car, the 2002 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect electrical connector for camshaft position sensor. Camshaft position sensor is located behind driver's side upper timing belt cover with electrical connector near front of upper timing belt cover. See Fig 1.
- Using ohmmeter, check resistance between electrical terminals on camshaft position sensor. Resistance should be 835-1400 ohms with sensor temperature of 14-122°F (-10-50°C) and 1060-1645 ohms with sensor temperature of 122-212°F (50-100°C). If resistance is within specification, go to next step. If resistance is not within specification, replace camshaft position sensor. See CAMSHAFT POSITION SENSOR under IGNITION SYSTEMS in REMOVAL, OVERHAUL & INSTALLATION - V6 & V8 article.
- Check for open and short in wiring harness and electrical connectors between camshaft position sensor and ECM. See WIRING DIAGRAMS article. ECM is located behind glove box. See Figure. If wiring harness and electrical connectors are okay, go to next step. If wiring harness or electrical connector is defective, repair as necessary.
- Remove camshaft position sensor. See CAMSHAFT POSITION SENSOR under IGNITION SYSTEMS in REMOVAL, OVERHAUL & INSTALLATION - V6 & V8 article. Inspect camshaft position sensor and signal plate on outer circumference of driver's side camshaft sprocket. If camshaft position sensor or signal plate is damaged, replace components as necessary. If camshaft position sensor and signal plate are okay, replace ECM.