Section 358 (Charging System - Generators & Regulators): Generator: Replacement

WARNING: This page is about a different car, the 2002 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.

Replace front bearing :
1. Remove the 4 screws and bearing retainer. See Fig 1.
  
  Fig 1: Removing Bearing Retainer
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Using SST and a press, press out the bearing. See Fig 2.
  SST 09950-60010 (09951-00260, 09952-06010)
  
  Fig 2: Identifying Bearing Removal SST
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Using SST and a press, press in a new bearing. See Fig 3.
  SST 09950-60010 (09951-00520)
4. Install the bearing retainer with the 4 screws.
Torque: 3.0 N.m (31 kgf.cm, 27 in..lbf)

Fig 3: Identifying Bearing Installation SST
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Replace rear bearing :
1. Using SST, remove the bearing cover (outside) and bearing. See Fig 4.
  SST 09820-00021
2. Remove the bearing cover (inside).
  
  Fig 4: Identifying Inside Outside Bearing Cover Removal SST
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Place the bearing cover (inside) on the rotor. See Fig 5.
  
  Fig 5: Identifying Bearing Cover
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Using SST and a press, press in a new bearing. See Fig 6.
  SST 09820-00031
  
  Fig 6: Identifying Bearing Installation SST
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Using SST, push in the bearing cover (outside). See Fig 7.
SST 09285-76010

Fig 7: Installing Outside Bearing Cover