LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2004 >> Matrix Base, FWD, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 39 (Engine Controls - Self-Diagnostics) >> Diagnostic Tests >> DTC P1120: Accelerator Pedal Position (App) Sensor Circuit >> Diagnosis & Repair (Using OBD-II Scan Tool)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Diagnosis & Repair (Using OBD-II Scan Tool)

WARNING: This page is about a different car, the 2002 Lexus LX 470. However, it is still accessible from the selected car via links, so may be relevant.
  1. Access ECM behind glove box. Turn ignition on. Using DVOM, backprobe ECM harness connector and measure voltage between terminals No. 2 (Blue/Red wire) and No. 18 (Brown/White wire) at ECM harness connector E7. See Figure. If voltage is 4.5-5.5 volts, go to next step. If voltage is not 4.5-5.5 volts, replace ECM.
  2. Using DVOM, backprobe ECM harness connector and measure voltage between terminals No. 18 (Brown/White wire) and No. 21 (Red wire) at ECM harness connector E7. With fully closed throttle, voltage should be .3-.9 volt. With fully open throttle, voltage should be 3.2-4.8 volts. Using DVOM, backprobe ECM harness connector and measure voltage between terminals No. 18 (Brown/White wire) and No. 9 (Red/Black wire) at ECM harness connector E7. With fully closed throttle, voltage should be 1.8-2.7 volts. With fully open throttle, voltage should be 4.7-5.1 volts. If voltage readings are as specified, replace ECM. If voltage readings are not as specified, go to next step.
  3. Check APP sensor. See ENGINE SENSORS & SWITCHES in SYSTEM & COMPONENT TESTING - LX470 article. If problem exists, replace APP sensor. If problem does not exist, repair open or short in wiring between ECM and APP sensor. See WIRING DIAGRAMS article.
scientia non olet · About LEMON Manuals