Inspection Procedure

WARNING: This page is about a different car, the 2002 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: In case of using the TOYOTA hand-held tester, start the inspection from step 1 and in case of not using the TOYOTA hand-held tester, start from step 2.

Check power window motor using TOYOTA hand-held tester.
Preparation : connect the TOYOTA hand-held tester to the DLC 3.

Check : that the power window motor can operate in an ACTIVE TEST.
1. OK : proceed to next circuit inspection shown on problem symptoms table. See PROBLEM SYMPTOMS .
2. NG : Go to next step.
Check power window motor. . See INSPECTION .
1. NG : Replace the power window motor.
2. OK : Go to step 3.
Check wire harness and connector between power window motor and passenger door ECU.
1. NG : Repair or replace wire harness or connector.
2. OK : proceed to next circuit inspection shown on problem symptoms table. See PROBLEM SYMPTOMS .