Step 1 - Install Electric Power Steering Gear Assembly

WARNING: This page is about a different car, the 2002 Toyota Prius and 2001 Toyota Prius. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: Install the bracket with the inscribed mark facing to the front of the vehicle.

Fig 1: Identifying Inscribed Mark & Installation Direction Of Bracket

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Fig 2: Locating Electric Power Steering Gear To Suspension Member Mounting Bolts

Install the grommet and bracket to the electric power steering gear assembly.
Install the electric power steering gear assembly with the 4 new bolts to the front suspension member.
Torque: 83 N.m (850 kgf.cm, 61 ft.lbf)
Install the STABILIZER BAR .
To prevent the main shaft lower dust seal from damaging, wind vinyl tape on the serrated part of the control valve shaft.

Fig 3: Identifying Control Valve Shaft Serrations
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Turn over the main shaft lower dust seal from the engine compartment side to the cab.

Fig 4: Determining Engine Compartment & Cab Side Of Main Shaft Lower Seal
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002