Diagnostic Trouble Code Chart
WARNING: This page is about a different car, the 2003 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.
TERMS MEANING
| Terms | Meaning |
|---|---|
| Physical Address | Three-Digit Code (Shown In Hexadecimal) Which Is Given To Each Component Comprising The AVC-LAN. Corresponding To The Function, Individual Symbols Are Specified. |
| Logical Address | Two-Digit Code (Shown In Hexadecimal) Which Is Given To Each Function Comprising The Inner System Of The AVC-LAN. |
NOTE:
DTC of the device which is directly connected via AVC-LAN, is displayed on the "radio and player" and the "rear display" respectively.
- RADIO AND PLAYER (Physical address: 190) NOTE:
- *1: Even if no failure is detected, this code may be stored depending on the battery condition or voltage for starting the engine.
- *2: This code is stored when 180 sec. has passed after the power supply connector is pulled out after engine start.
- *3: This code may be stored when the engine key is turned again 1 min. after engine start.
- *4: This code may be stored when the engine key is turned again after engine start.
- *5: When 210 sec. has passed after pulling out the power supply connector of the master component with the ignition switch in ACC or ON, this code is stored.
- Logical address: 01 (Communication control)
- Logical address: 61 (Cassette switch)
- RSE ECU (Physical address: 1F6, 16C) NOTE:
- *1: Even if no failure is detected, this code may be stored depending on the battery condition or voltage for starting an engine.
- *2: This code is stored when 180 sec. has passed after the power supply connector is pulled out after engine start.
- Main (1F6)
Logical address: 01 (Communication control)
- Sub (16C)
Logical address: 01 (Communication control)
- REAR DISPLAY (Physical address: 1B0) NOTE:
- *1: Even if no failure is detected, this code may be stored depending on the battery condition or voltage for starting an engine.
- *2: This code may be stored when the engine key is turned again 1 min. after engine start.
- *3: This code may be stored when the engine key is turned again after engine start.
- Logical address: 01 (Communication control)
- RSA PANEL (Physical address: 1F4) NOTE:
- *1: Even if no failure is detected, this code may be stored depending on the battery condition or voltage for starting the engine.
- *2: When 210 sec. has passed after pulling out the power supply connector of the master component with the ignition switch in ACC or ON, this code is stored.
- *3: This code may be stored when the engine key is turned 1 min. again after engine start.
- *4: This code may be stored when the engine key is turned again after engine start.
- Logical address: 01 (Communication control)
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
- DVD PLAYER (Physical address :1A0) NOTE:
- *1: Even if no failure is detected, this code may be stored depending on the battery condition or voltage for starting an engine.
- *2: This code may be stored when the engine key is turned again 1 min. after engine start.
- *3: This code may be stored when the engine key is turned again after engine start.
- *4: When 210 sec. has passed after pulling out the power supply connector of the master component with the ignition switch in ACC or ON, this code is stored.
- Logical address: 01 (Communication control)
- Logical address: 44 (DVD)
LOGICAL ADDRESS: 44 (DVD) (DVD PLAYER) DIAGNOSTICDTC Diagnosis Item Condition Countermeasure And Inspected Parts 42 No Disc Readout Disc Cannot Be Read Inspect Disc. 44 DVD Error Error Is Detected In DVD Player Replace DVD Player. 45 EJECT Error Disc Cannot Be Ejected. Replace DVD Player. 46 Disc Crack A Crack And Dirt Are In A Disc. Replace DVD Player. 52 Player Error Clamp Unusually Generating. Replace DVD Player.