Diagnostic Trouble Code Table

WARNING: This page is about a different car, the 2004 Toyota Camry Solara. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Diagnostic Trouble Code Table

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT:

Titles for each unit are stated in the following order: physical address (parts name).

190 (RADIO RECEIVER ASSY)
1. Logical address: 01 (Communication control)
  
  Fig 2: Logical Address: 01 (Communication Control) Table (1 Of 2)
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  Fig 3: Logical Address: 01 (Communication Control) Table (2 Of 2)
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  HINT:
  - ^*1 : This code may be recorded depending on the battery condition or engine start voltage even if no failure is detected.
  - ^*2 : If the power connector is disconnected after the engine starts, this code is recorded after 180 seconds.
  - ^*3 : This code may be stored if the ignition key is turned to the START position again with the engine running.
  - ^*4 : This code may be stored if the ignition key is held in the START position for one minute or more before returning to the ON position.
2. Logical address: 61 (Cassette switch)
  
  Fig 4: Logical Address: 61 (Cassette Switch) Table
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Logical address: 62 (CD player)
  
  Fig 5: Logical Address: 62 (CD Player) Table
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Logical address: 63 (In-dash CD changer)
Fig 6: Logical Address: 63 (In-Dash CD Changer) Table
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
440 (STEREO COMPONENT AMPLIFIER ASSY)
Logical address: 01 (Communication control)

Fig 7: Logical Address: 01 (Communication Control) Table (1 Of 2)
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Fig 8: Logical Address: 01 (Communication Control) Table (2 Of 2)
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

HINT:
- ^*1 : This code may be recorded depending on the battery condition or engine start voltage even if no failure is detected.
- ^*2 : This code may be stored if the ignition key is turned to the START position again with the engine running.
- ^*3 : This code may be stored if the ignition key is held in the START position for one minute or more before returning to the ON position.
- ^*4 : If the device is reported as not existing during verification, check the power source circuit and AVC-LAN circuit for the device.