Inspection Procedure
WARNING: This page is about a different car, the 2004 Toyota Camry Solara. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK DISPLAY SETTING
- Check that the display is not in "Screen OFF" mode.
OK: The display setting is not in "Screen OFF" mode.
- NG: CHANGE SCREEN TO "SCREEN ON" MODE
- OK: Go to Next Step.
- Check that the display is not in "Screen OFF" mode.
- CHECK IMAGE QUALITY SETTING
- Check if screen color quality can be set.
OK: Screen color quality can be set.
- OK: PRESS PANEL SWITCH "DISPLAY" AND SET SCREEN COLOR QUALITY TO NORMAL
- NG: Go to Next Step.
- Check if screen color quality can be set.
- CHECK CABIN
- Check if condensation is likely to occur, or the temperature is high or low (extremely cold) in the cabin.
HINT:
This problem occurs when the cabin is humid and the temperature rapidly changes. This condition may produce condensation, resulting in a short circuit.
OK: The above conditions are not observed.
- NG: SET CABIN TEMPERATURE TO APPROPRIATE DEGREES (20 TO 30°C) (68 TO 86°F)
- OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (SEE PROBLEM SYMPTOMS TABLE )
- Check if condensation is likely to occur, or the temperature is high or low (extremely cold) in the cabin.