Inspection Procedure
WARNING: This page is about a different car, the 2004 Toyota Camry Solara. However, it is still accessible from the selected car via links, so may be relevant.
- CHECK HARNESS AND CONNECTOR (TC of DLC3 - ECM)
- Turn the ignition switch off.
- Disconnect the E4 connector of the ECM.
- Measure the resistance according to the value(s) in the table below.
Standard:
CONNECTOR SPECIFICATIONTester connection Condition Specification TC (DLC3-13) -TC (E4-20) Always Below 1 Ω
- NG : REPAIR OR REPLACE HARNESS OR CONNECTOR (TC of DLC3 - ECM)
- OK : Go to next step
- CHECK HARNESS AND CONNECTOR (TC of DLC3 - BODY GROUND)
- Measure the resistance according to the value(s) in the table below.
Standard:
CONNECTOR SPECIFICATIONTester connection Condition Specification TC (DLC3-13) -Body ground Always 10 kΩ or higher
- NG : REPAIR OR REPLACE WIRE HARNESS OR EACH ECU (TC CIRCUIT)
- OK : Go to next step
- Measure the resistance according to the value(s) in the table below.
- CHECK HARNESS AND CONNECTOR (CG of DLC3 - BODY GROUND)
- Measure the resistance according to the value(s) in the table below.
Standard:
CONNECTOR SPECIFICATIONTester connection Condition Specification CG (DLC3-4) -Body ground Always Below 1 Ω
- NG : REPAIR OR REPLACE HARNESS OR CONNECTOR (CG of DLC3 - BODY GROUND)
- OK : REPLACE ECM (SEE REPLACEMENT (2AZ-FE) or REPLACEMENT (3MZ-FE))
- Measure the resistance according to the value(s) in the table below.