Section 949 (Cruise Control Systems): Servo: Removal

WARNING: This page is about a different car, the 2004 Chrysler Pacifica. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the negative battery cable.
Remove the servo bracket bolt.
Remove speed control cable from throttle cam by sliding clasp out hole used for throttle cable (Fig 1 ).

Fig 1: Identifying Cable Routing
Courtesy of DAIMLERCHRYSLER CORP.
Remove the throttle cable (with retaining tab) and then slide cable speed control cable out from bracket.
Disconnect electrical connectors and vacuum hose.
Remove two nuts attaching mounting bracket and speed control cable to servo (Fig 2 ).

Fig 2: Removing Nuts Attaching Mounting Bracket
Courtesy of DAIMLERCHRYSLER CORP.
Pull cable away from servo to expose retaining clip and remove clip attaching cable to servo (Fig 3 ).

Fig 3: Removing Clip Attaching Cable To Servo
Courtesy of DAIMLERCHRYSLER CORP.
Remove the servo.