LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2004 >> Matrix Base, FWD, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 957 (Fuel Delivery System) >> Fuel Pressure Regulator >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Fuel Pressure Regulator: Installation

WARNING: This page is about a different car, the 2004 Chrysler Pacifica. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: The O-rings should be placed on the regulator first, to prevent them from being rolled out of position during regulator installation.
  1. Lightly lubricate the O-rings with clean engine oil and place them into opening in module.
  2. Push regulator down and into place.
  3. Install ground wire.
  4. Install the module top to the module and gasket seal.
  5. Ensure seal is properly positioned in the fuel tank groove.
  6. Install the Fuel Pump Module lock ring.
    NOTE: Use a brass punch to Install the 1/4 turn lock ring. Make sure all 5 tabs are properly seated.
  7. Connect the fuel line and vapor lines.
  8. Install fuel tank. Refer to FUEL TANK .
  9. Connect the negative battery cable.
  10. Fill fuel tank. Use the DRBIII® scan tool to pressurize the fuel system. Check for leaks.
scientia non olet · About LEMON Manuals