Torque Specification
Torque Specification - Power Steering
| Part tightened | N.m | kgf.cm | ft.lbf | |
|---|---|---|---|---|
| POWER STEERING VANE PUMP | ||||
| Vane pump housing rear x Vane pump housing front | 22 | 220 | 16 | |
| Pressure port union | 69 | 700 | 51 | |
| Suction port union set bolt | 12 | 122 | 9 | |
| Oil pressure switch | 21 | 210 | 15 | |
| Vane pump assy x Vane pump bracket rear | 37 | 380 | 27 | |
| Vane pump assy set bolt | 37 | 380 | 27 | |
| Pressure feed tube assy x Vane pump assy | 41 (44) | 420 (450) | 30 (33) | |
| Pressure feed tube assy clamp set bolt | 7.8 | 80 | 69 in..lbf | |
| POWER STEERING GEAR | ||||
| Engine hanger set bolt | 38 | 390 | 28 | |
| Control valve housing set bolt | 18 | 185 | 13 | |
| Self-locking nut | 25 | 250 | 18 | |
| Rack housing cap | 59 | 600 | 43 | |
| Rack guide spring cap lock nut | 43 (59) | 440 (600) | 32 (43) | |
| Power steering rack x Rack end | 62 (83) | 630 (850) | 46 (61) | |
| Tie rod assy lock nut | 74 | 750 | 54 | |
| Turn pressure tube union nut | 12 (13) | 120 (130) | 9 (9) | |
| Rack & pinion power steering gear assy set bolt and nut | 2WD | 58 | 590 | 43 |
| 4WD | 82 | 835 | 60 | |
| Pressure feed and return tubes x Control valve housing | 23 (25) | 235 (255) | 17 (18) | |
| Pressure teed tube clamp set bolt | 7.8 | 80 | 69 in..lbf | |
| Stabilizer link assy set nut | 74 | 755 | 55 | |
| Tie rod assy set nut | 49 | 500 | 36 | |
| Intermediate shaft sub-assy x Control valve shaft | 35 | 360 | 26 | |
| Front suspension crossmember sub-assy x Frame | Bolt A | 157 | 1,600 | 116 |
| Bolt B | 157 | 1,600 | 116 | |
| Center member x Frame | 39 | 400 | 29 | |
| Center member x Engine mounting insulator FR | 52 | 530 | 38 | |
| Crossmember x Engine mounting insulator RR | 52 | 530 | 38 | |
| Front suspension arm sub-assy lower No.1 x Lower ball joint | 89 | 910 | 66 | |
| Hub nut | 103 | 1,050 | 76 | |
| ( ): For use without SST | ||||