Basic Inspection

When the malfunction is not confirmed in the DTC check, troubleshooting should be carried out in all the possible circuits considered as causes of the problem. In many cases, by carrying out the basic engine check shown in the following flowchart, the location causing the problem can be found quickly and efficiently. Therefore, using this check is essential in the engine troubleshooting.

1. CHECK BATTERY VOLTAGE 
   NOTE: Carry out this check with the engine stopped and power switch OFF.
   VOLTAGE CAPACITY
   
   

   	OK	NG
   Voltage	11 V or more	Less than 11 V

   NG: CHARGE OR REPLACE BATTERY 

   OK: GO TO NEXT STEP 

2. CHECK IF ENGINE WILL CRANK 

   NG: PROCEED TO PROBLEM SYMPTOMS TABLE ON  PROBLEM SYMPTOMS TABLE  

   OK: GO TO NEXT STEP 

3. CHECK IF ENGINE STARTS 

   NG: GO TO STEP   6 

   OK: GO TO NEXT STEP 

4. CHECK AIR FILTER 
   1. Visually check if the air filter is not contaminated dirt or oil.

   NG: REPLACE 

   OK: GO TO NEXT STEP 

5. CHECK IDLE SPEED (See  ENGINE MECHANICAL  ) 

   NG: PROCEED TO  ENGINE MECHANICAL  AND CONTINUE TO TROUBLESHOOT 

   OK: GO TO NEXT STEP 

   PROCEED TO PROBLEM SYMPTOMS TABLE ON  PROBLEM SYMPTOMS TABLE  

6. CHECK FUEL PRESSURE (See  FUEL SYSTEM  ) 

   NG: PROCEED TO  IGNITION  AND CONTINUE TO TROUBLESHOOT 

   OK: GO TO NEXT STEP 

7. CHECK FOR SPARK (See  IGNITION  ) 

   NG: PROCEED TO  IGNITION  AND CONTINUE TO TROUBLESHOOT 

   OK: GO TO NEXT STEP 

   PROCEED TO PROBLEM SYMPTOMS TABLE ON  PROBLEM SYMPTOMS TABLE