Inspection Procedure

WARNING: This page is about a different car, the 2002 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: In case of using the TOYOTA hand-held tester, start the inspection from step 1 and in case of not using the TOYOTA hand-held tester, start from step 2.

Check The Back Door Lock Motor Using TOYOTA Hand-Held Tester.
PREPARATION: Connect the TOYOTA hand-held tester to the DLC3.

CHECK: that the back door lock motor can operate in an ACTIVE TEST.
1. OK: Proceed to next circuit inspection shown on problem symptom table. See PROBLEM SYMPTOMS TABLE .
2. NG : Go to step 2.
Check Back Door Lock Motor .
1. NG: Replace the back door lock motor.
2. OK: Go to step 3.
Check Wiring Harness And Connector Between Back Door Lock Motor And Back Door ECU.
1. NG: Repair or replace wiring harness or connector.
2. OK: Proceed to next circuit inspection shown on problem symptoms table . SeePROBLEM SYMPTOMS TABLE .