How To Reset Power Window Motor (Reset Switch And Pulse Switch)

If the jam protection function is not working properly, perform the following procedure.

HINT:

The power window motor limit switch must be reset to its initial position after:

• Separating the window regulator from the power window motor.
• Operating the window regulator with the door glass not installed.

1. Remove the power window motor (see COMPONENTS and COMPONENTS ).

   HINT:

   Place the matchmarks on the power window motor and window regulator gear.

2. Connect the power window motor and power window switch to the wire harness of the vehicle.
3. Turn the ignition switch ON. Pull the power window switch UP button to idle the power window motor in the UP side direction for more than 6 rotations or less than 10 rotations (4 seconds or more).
4. Assemble the power window motor and regulator.

   HINT:

   • Install the motor when the regulator arm is below the middle point.
   • Align the matchmarks on the power window motor and window regulator gear when installing the power window motor.
5. Assemble the power window regulator and door glass.

   HINT:

   Never rotate the motor downward until the completion of the window glass installation.

6. Connect the power window switch to the wire harness and turn the ignition switch ON.
7. Repeat UP and DOWN operation several times manually.
8. Check if AUTO UP and AUTO DOWN operates.

   HINT:

   • Take care that the jam protection function does not operate just after being reset.
   • Reset the regulator again when performing the reverse operation after fully closing the window by AUTO UP operation.
9. Check the power window function.