Power Slide Back Window System (Except Double Cab): Inspection

If the continuity is not as specified, replace the switch.

Fig 1: Identifying Power Slide Back Window Switch Connector Terminals

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. Disconnect the connector from the window motor.
2. Connect the positive (+) lead from the ammeter to terminal 1 of the motor connector and the negative (-) lead to the negative terminal of the battery.
3. Connect the positive (+) lead from the battery to terminal 2 of the motor connector, and slide the window to the fully closed position.
   Fig 2: Checking Power Slide Back Window PTC Thermistor Connector Terminals Current

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Continue to apply voltage and check that the current changes to less than 1 A in 4 to 90 seconds.
5. Disconnect the leads from the terminals.
6. Approximately 60 seconds later, connect the positive (+) lead from the battery to terminal 1 and the negative (-) lead to terminal 2, and check that the window begins to slide open.

   If operation is not as specified, replace the regulator and motor assembly.

   Fig 3: Checking Power Slide Back Window Motor PTC Thermistor Operation

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

If the continuity is not as specified, replace the relay.

Fig 4: Checking Power Relay Continuity

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Remove the integration relay from the driver side J/B, and check the voltage or continuity of each terminal on the driver side J/B side (see INSPECTION ).

Fig 5: Checking Drive Side J/B Side Integration Relay

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002