Starter Relay Test

Locate and remove starter relay. Starter relay is marked "ST". See Fig 1. Using ohmmeter, verify continuity between relay terminals No. 1 and 2. See Fig 2. Continuity should not exist between terminals No. 3 and 5. If continuity is not as specified, replace relay.
Check relay operation by applying battery voltage through terminals No. 1 and 2. See Fig 2. Continuity should now exist between terminals No. 3 and 5. If relay does not test as indicated, replace relay.
If OK, reinstall starter test relay.

Fig 1: Locating Starter Relay

Fig 2: Testing Starter Relay