Rear Brake Speed Sensor: Removal

DISCONNECT SPEED SENSOR CONNECTOR
REMOVE SPEED SENSOR
1. Remove the 2 clamp bolts, clamp nut and 5 resin clips holding the sensor wire harness from the axle and the fuel tank.
  Torque: 13 N.m (130 kgf.cm, 9 ft.lbf)
  
  HINT:
  - When installing the rear sensor wire harness, never use the removed resin clips, which are service parts.
  - When replacing clips, set up new resin clips at the same angle of the removed resin clips.
2. Remove the bolt and speed sensor from the axle carrier.
  Torque: 8.0 N.m (82 kgf.cm, 71 in.lbf)
  
  Fig 1: Identifying Speed Sensor Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002