Data List/Active Test

HINT:

Using the DATA LIST displayed on the hand-held tester, you can read the value of the switch, sensor, actuator, etc. without parts removal. Reading the DATA LIST as the first step of troubleshooting is one way to shorten the labor time.

1. Connect the hand-held tester to the DLC3.
2. Turn the ignition switch on (IG).
3. Read the DATA LIST according to the display on the tester.
   DATA LIST
   
   

   Item	Measurement Item/Display (Range)	Normal Condition
   MIRR POS SEN V	Vertical mirror position/MIN: 0, MAX: 5 V	Within range from 0 to 5 V
   MIRR POS SEN H	Horizontal mirror position/MIN: 0, MAX: 5 V	Within range from 0 to 5 V
   FOOT LAMP SETUP	Foot lamp illumination time	OFF/7.5S/15S/30S
   MIRROR MEM 1	Mirror position is memorized in memory switch M1/NOT MEM or MEM	MEM: Memorized NOT MEM: Not memorized
   MIRROR MEM 2	Mirror position is memorized in memory switch M2/NOT MEM or MEM	MEM: Memorized NOT MEM: Not memorized

HINT:

Performing the ACTIVE TEST using the hand-held tester allows you to operate the relay, VSV, actuator, etc. without parts removal. Performing the ACTIVE TEST as the first step of troubleshooting is one way to shorten the labor time.

It is possible to display the DATA LIST during the ACTIVE TEST.

1. Connect the hand-held tester to the DLC3.
2. Turn the ignition switch on (IG).
3. Perform the ACTIVE TEST according to the display on the tester.

   Standard (Outer mirror control ECU): 

   ACTIVE TEST
   
   

   Item	Test Details
   MIRR UP/DOWN	Mirror vertical operation UP/DOWN
   MIRR RIGHT/LEFT	Mirror horizontal operation RIGHT/LEFT
   FOOT LIGHT	Illumination operation ON/OFF