Inspection Procedure

1. Connect the hand-held tester to the DLC3.
2. Turn the ignition switch ON and push the hand-held tester main switch ON.
3. Select the item "CCS READY" in the DATA LIST and read its value displayed on the hand-held tester.

OK: 

ON" <=> "OFF: Change ON/OFF each time Main SW is pressed on. 

1. NG: CHECK AND REPLACE ECM 
2. OK: GO TO NEXT STEP. 

   PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (See  PROBLEM SYMPTOMS TABLE   )