Typical Enabling Condition
M/T:
TYPICAL ENABLING CONDITION TABLE - M/T
| The monitor will run whenever the following DTCs are not present | See "List of Disable a Monitor" (in PRE-CHECK ) | ||
| Stop and Go(1) | 8 times or more | ||
|
|||
SMT:
TYPICAL ENABLING CONDITION TABLE - SMT
| The monitor will run whenever the following DTCs are not present | See "List of disable a monitor" (in PRE-CHECK ) |
| Either of following conditions A or B is set | 12 seconds or less |
| A. Ignition switch | ON |
| B. ETCS power | ON |
| Idle | OFF |
| VTA2 voltage | Less than 4.8 V |