Typical Enabling Condition
TYPICAL ENABLING CONDITION TABLE
| The monitor will run whenever the following DTCs are not present | See "List of disable a monitor" (in PRE-CHECK ) |
| System guard* | ON |
| Throttle actuator current | 2 A or more |
| Throttle actuator close duty-cycle | 80% or more |
| *System guard is set when following conditions are met | |
| Throttle actuator | ON |
| Throttle actuator duty calculation | Executed |
| Throttle position sensor PASS or FAIL determination | PASS |
| Throttle actuator current-cut operation | Not executed |
| Throttle actuator power supply | 4 V or more |
| Throttle actuator PASS or FAIL determination | PASS |