Torque Specifications
1ZZ-FE/2ZZ-GE:
TIGHTENING TORQUE SPECIFICATIONS (1ZZ-FE/2ZZ-GE)
| Part Tightened | N.m | kgf.cm | ft.lbf | |
|---|---|---|---|---|
| Lead wire at Terminal C | 10 | 102 | 7 | |
| Starter assy at Transaxle housing assy | 37 | 378 | 27 | |
| Starter wire at Starter assy | 9.8 | 100 | 7 | |
| Battery negative terminal at Battery | 5.4 | 55 | 48 in.lbf | |
| Starter commutator end frame assy at Starter drive housing assy | 6.0 | 61 | 53 in.lbf | |
| Magnet switch at Starter drive housing assy | 7.5 | 76 | 66 in.lbf | |
| Generator assy at Engine mounting bracket RH | 25 | 250 | 18 | |
| Generator assy at Timing chain cover sub-assy | 1ZZ-FE | 54 | 550 | 40 |
| 2ZZ-GE | 58 | 590 | 43 | |
| Wire harness clamp bracket at Engine mounting bracket RH (2ZZ-GE) | 5.4 | 55 | 48 in.lbf | |
| Generator wire at Generator assy | 9.8 | 100 | 7 | |
| Generator bracket No. 1 at Generator assy (2ZZ-GE) | 29 | 296 | 21 | |
| Generator bracket No. 1 at Intake air surge tank (2ZZ-GE) | 29 | 296 | 21 | |
| Air pump outlet pipe at Body | 7.0 | 71 | 62 in.lbf | |
| Retainer plate at Generator drive end frame (1ZZ-FE) | 3.0 | 31 | 27 in.lbf | |
| Generator rectifier end frame at Generator drive end frame | 4.5 | 46 | 40 in.lbf | |
| Generator cord clip at Generator drive end frame | 5.4 | 55 | 48 in.lbf | |
| Generator w/rectifier holder at Generator drive end frame | 2.9 | 30 | 26 in.lbf | |
| Generator regulator assy at Generator rectifier end frame | 2.0 | 20 | 18 in.lbf | |
| Generator brush holder assy at Generator rectifier end frame | 2.0 | 20 | 18 in.lbf | |
| Generator rear end cover at Generator rectifier end frame | 4.4 | 45 | 39 in.lbf | |
| Terminal plate at Generator rectifier end frame | Bolt | 3.9 | 40 | 35 in.lbf |
| Nut | 4.4 | 45 | 39 in.lbf | |
| Generator pulley at Generator rotor assy | 111 | 1,132 | 82 | |