Data List / Active Test

1. While the intelligent tester is connected to the DLC3 with the ignition switch turned on (IG), the CRUISE CONTROL data list can be displayed. Follow the prompts on the tester screen to access the data list.

   CC (ECM): 

   DATA LIST
   
   

   Item	Measurement Item / Display (Range)	Normal Condition	Diagnostic Note
   VEHICLE SPD	Vehicle speed / min.: 0 km/h (0 mph), max.: 255 km/h (158 mph)	Actual vehicle speed	-
   MEMORY SPD	Cruise control memorized speed / min.: 0 km/h (0 mph), max.: 255 km/h (158 mph)	Actual stored vehicle speed	-
   RQST TORQUE	Cruise request torque / min.: -1,024 N*m, max.: 1016 N*m	Actual torque	-
   CRUISE CONTROL	Cruise control system active condition / ON or OFF	ON: Cruise control activated OFF: Cruise control inactivated	-
   MAIN SW (MAIN)	Main switch signal (Main CPU) / ON or OFF	ON: Main switch ON (Pushed on) OFF: Main switch OFF (Pushed off)	"3"
   CCS READY M	Cruise control system standby condition (Main CPU) / ON or OFF	ON --> OFF: Change ON/OFF each time Main SW is pushed in.	"1"
   CCS INDICATOR M	Cruise indicator signal (Main CPU) / ON or OFF	ON: "CCS READY" ON OFF: "CCS READY" OFF	"2"
   CANCEL SW	CANCEL switch signal / ON or OFF	ON: CANCEL switch ON OFF: CANCEL switch OFF	-
   SET/- SW	SET/- SW signal / ON or OFF	ON: SET/- SW ON OFF: SET/- SW OFF	-
   RES/+ SW	RES/+ SW signal / ON or OFF	ON: RES/+ SW ON OFF: RES/+ SW OFF	-
   STP LIGHT SW M	Stop light SW signal (Main CPU) / ON or OFF	ON: Brake pedal depressed OFF: Brake pedal released	-
   SHIFT D POS	PNP SW signal (D position) / ON or OFF	ON: Shift position D OFF: Any shift position except D	-

   HINT:

   "3" is OK but "1" is NG --> ECM failure

   "1" is OK but "2" is NG --> DTC output or ECM failure

   "3" is OK but cruise indicator not turn on --> CRUISE MAIN indicator or wire harness or ECM failure

HINT:

Performing the ACTIVE TEST using the intelligent tester allows components such as the relay, VSV, and actuator to operate with out parts removal. Performing the ACTIVE TEST as the first step of troubleshooting is one way to shorten labor time.

It is possible to display the DATA LIST during the ACTIVE TEST.

1. Connect the intelligent tester to the DLC3.
2. turn the ignition switch on (IG).
3. According to the display on the tester, perform the "ACTIVE TEST".

   HINT:

   The ignition switch must be turned on (IG) to proceed with the ACTIVE TEST using the intelligent tester.

   COMBINATION METER ASSEMBLY: 

   DATA LIST
   
   

   Item	Vehicle Condition / Test Details	Diagnostic Note
   CRUISE INDIC	"CRUISE" indicator is ON / OFF	-