Inspection Procedure

1. Connect the intelligent tester to the DLC3.
2. Check the CRUISE main indicator light by using ACTIVE TEST.

   Combination Meter: 

   ACTIVE TEST
   
   

   Item	Test Details	Diagnostic Note
   CRUISE INDIC	"CRUISE" indicator is ON/OFF	-

   OK: 

   Indicator light comes on / goes off. 

NG: REPLACE COMBINATION METER 

OK: Go to Next Step 

1. Connect the intelligent tester to the DLC3.
2. Turn the ignition switch on (IG), and turn the intelligent tester main switch on.
3. Check the DATA LIST for proper functioning of the CRUISE main indicator light.

   CC (ECM): 

   DATA LIST
   
   

   Item	Measurement Item / Display (Range)	Normal Condition	Diagnostic Note
   CCS INDICATOR M	Cruise indicator signal (Main CPU) / ON or OFF	ON: "CCS READY" ON OFF: "CCS READY" OFF	-

   OK: 

   When cruise control main switch operation is performed, the result will be same as above. 

NG: REPLACE ECM 

OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE