LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Toyota >> 2006 >> Matrix Base, FWD, Automatic >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Control System (1ZZ-FE) - SFI System (For 4WD) - Introduction, System & Circuit Checks >> SFI SYSTEM (for 4WD) >> Fail-Safe Chart
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Fail-Safe Chart

If any of the following DTCs are set, the ECM enters fail-safe mode to allow the vehicle to be driven temporarily.

FAIL-SAFE

DTCs Components Fail-Safe Operations Fail-Safe Deactivation Conditions
P0031, P0032, P0037 and P0038 Heated Oxygen (HO2) Sensor Heater ECM turns off HO2 sensor heater. Ignition switch OFF
P0100, P0102 and P0103 Mass Air Flow (MAF) Meter ECM calculates ignition timing according to engine speed and throttle valve position. Pass condition detected
P0110, P0112 and P0113 Intake Air Temperature (IAT) Sensor ECM estimates IAT to be 20°C (68°F). Pass condition detected
P0115, P0117 and P0118 Engine Coolant Temperature (ECT) Sensor ECM estimates ECT to be 80°C (176°F). Pass condition detected
P0120, P0121, P0122 and P0123 Throttle Position (TP) Sensor ECM adjusts engine output by controlling fuel injection (intermittent fuel-cut) Pass condition detected and ignition switch OFF
P0327 and P0328 Knock Sensor ECM sets ignition timing to maximum retard. Ignition switch OFF
P0351 to P0354 Igniter ECM cuts fuel. Pass condition detected
scientia non olet · About LEMON Manuals