Typical Enabling Conditions
WARNING: This page is about a different variant/trim than selected.
TYPICAL ENABLING CONDITIONS
| The monitor will run whenever the following DTCs are not present | P0031, P0032 (O2 sensor heater sensor 1), P0100, P0102, P0103 (MAF sensor), P0110, P0112, P0113 (IAT sensor), P0115, P0117, P0118 (ECT sensor), P0120, P0122, P0123 (TP sensor), P0125 (Insufficient ECT for closed loop), P0134 (O2 sensor, A/F sensor (No activity) sensor 1), P0171, P0172 (Fuel system), P0300, P0301, P0302, P0303, P0304,(Misfire), P0335 (CKP sensor), P0340, P0341 (CMP sensor), P0450, P0451, P0452, P0453 (EVAP system), P0500 (VSS), P0511(IAC valve), P2440 (A/R control valve stuck open) P2441 (A/R control valve stuck close), P2444 (AIP stuck ON), P2445 (AIP stuck OFF) |
| Duration that vehicle has run with the following conditions (a) and (b) | 30 seconds or more |
| (a) Vehicle speed | 25 mph (40 km/h) or more |
| (b) Engine speed | 900 rpm or more |
| MAF | 4 to 16 g/sec |
| Time after engine start | 120 seconds or more |
| Idle | OFF |
| Fuel system status | Closed loop |
| Engine speed | 1,000 to 4,000 rpm |
| Fuel-cut | OFF |
| Engine coolant temperature | 70°C (158°F) or more |