DTC 01-D5 Absence of Registration Unit; DTC 01-D8 No Response for Connection Check; DTC 01-D9 Last Mode Error; DTC 01-DA No Response Against ON / OFF Command; DTC 01-DB Mode Status Error; DTC 01-DE Slave Reset: Description
DIAGNOSTIC TROUBLE CODE CHART
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| 01-D5*1, *3 | When either condition below is met:
|
|
| 01-D8*2, *3 | Component shown by sub-code is (was) disconnected from system after hybrid system start. | |
| 01-D9*1, *3 | Device that had functioned before the hybrid system stopped is (was) disconnected from system when power switch is (was) ON (IG or ACC). | |
| 01-DA*3 | When either condition below is met:
|
|
| 01-DB*1, *3 | Dual alarm is detected. | |
| 01-DE*3 | Slave device has been disconnected after hybrid system start. |
HINT:
- *1: Even if no fault is present, this trouble code may be stored depending on the battery condition or hybrid system start voltage.
- *2: If the power connector is disconnected after the hybrid system starts, this code is stored after 180 seconds.
- *3: If it is reported that the device does not exist during verification, check the power source circuit and AVC-LAN circuit for the device.
NOTE:
- Before starting troubleshooting, be sure to clear DTCs to erase codes stored due to the reasons described in the HINT above. Then, check for DTCs and troubleshoot according to the output DTCs.
- The multi-display is the master unit.
- Be sure to clear and recheck DTCs after the inspection is completed to confirm that no DTCs are output.