April 5, 2026: LEMON Manuals is launched! Read the announcement.

Repair Instruction: Initialization

NOTE: When disconnecting the battery terminal, initialize the following systems after the terminal is reconnected.

SYSTEM

System Name
Back Door Power Window Control System

INITIALIZE BACK DOOR POWER WINDOW CONTROL SYSTEM
NOTE: Resetting the power window regulator motor (initializing the pulse sensor) is necessary if: 1) the battery terminal cable is disconnected; 2) the back door ECU, wire harness, power window regulator switch, power window regulator assembly and power window regulator motor are replaced or removed/ installed; or 3) the P/W fuse is replaced or removed. If resetting is not performed, the master switch assembly will not be able to operate the AUTO operation function, jam protection function and remote operation function.
1. Turn the ignition switch ON (*1). The mode select is operated by the automatic glare-proof / non-glare-proof switch on the inner mirror.
2. Open the power window halfway by pressing the power window switch (*2).
3. Fully pull up on the switch until the power window is fully closed and continue to hold the switch for at least 1 second (*3).
4. Check that the AUTO UP/DOWN function operates normally (*4).
  If the AUTO UP/DOWN function operates normally, reset operations are complete. If abnormal, follow the steps below.
5. Disconnect the negative battery terminal cable for 10 seconds.
6. Connect the battery terminal cable.
7. Perform the steps (*1) to (*4) again.