SFI System: Precaution
- INITIALIZATION NOTE:
- When disconnecting the negative (-) battery cable, initialize the following systems after the cable is reconnected.SYSTEM NAME REFERENCE
System Name See procedure Power Window Control System INITIALIZATION Sliding Roof System INITIALIZATION - Perform RESET MEMORY (AT initialization) when replacing the automatic transaxle assembly, engine assembly or ECM (See MANUAL SHIFTING TEST ).
- Perform REGISTRATION (VIN registration) when replacing the ECM (See REGISTRATION ).
- When disconnecting the negative (-) battery cable, initialize the following systems after the cable is reconnected.
- EXPRESSION OF IGNITION SWITCH
HINT:
The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this article.
EXPRESSION OF IGNITION SWITCHExpression Ignition switch (position) Engine switch (condition) Ignition switch off LOCK Off Ignition switch on (IG) ON On (IG) Ignition switch on (ACC) ACC On (ACC) Engine Start START Start - FOR USING INTELLIGENT TESTER CAUTION: Observe the following items for safety reasons:
- Before using the tester, read the instruction manual.
- Prevent the tester cable from being caught on the pedals, shift lever and steering wheel when driving with the tester connected to the vehicle.
- When driving the vehicle for testing purposes using the tester, two persons are required. One is for driving the vehicle, and the other operates the tester.
- FOR USING BATTERY DURING INSPECTION
- While using the battery during inspection, do not bring the positive and negative tester probes too close to each other as a short circuit may occur.