How To Proceed With Troubleshooting
HINT:
- Use these procedures to troubleshoot the dynamic radar cruise control system.
- The intelligent tester should be used at steps 3, 4, 5, and 9.
- VEHICLE BROUGHT TO WORKSHOP
- INSPECT BATTERY VOLTAGE
Standard:
11 to 14 V
If the voltage is below 11V, replace or recharge the battery before proceeding.
- CHECK COMMUNICATION FUNCTION OF MULTIPLEX COMMUNICATION SYSTEM (BEAN)
- Use the intelligent tester to check if the Multiplex Communication System (MPX) is functioning normally.
Result
RESULT REFERENCEResult Proceed to MPX DTC is not output A MPX DTC is output B B: Go to MULTIPLEX COMMUNICATION SYSTEM
A: Go to Next Step
- CHECK COMMUNICATION FUNCTION OF CONTROLLER AREA NETWORK (CAN)
- Use the intelligent tester to check for normal function of CAN communication system.
- Perform bus check (communication malfunction DTC).
- Perform bus check (communication bus check).
Result
RESULT REFERENCEResult Proceed to DTC is not output A DTC is output B
B: Go to CAN COMMUNICATION SYSTEM
A: Go to Next Step
- Use the intelligent tester to check for normal function of CAN communication system.
- CHECK FOR DTC
Refer to the DTC check/clear (See DTC CHECK / CLEAR ).
- Check for DTC and note any codes that are output.
- Delete the DTC.
- Recheck for DTC. Try to prompt the DTC by simulating the original activity that the DTC suggests.
Result
RESULT REFERENCEResult Proceed to DTC does not reoccur A DTC reoccur B
B: Go to step 8
A: Go to Next Step
- PROBLEM SYMPTOMS TABLE
Refer to the problem symptoms table (See PROBLEM SYMPTOMS TABLE ).
Result
RESULT REFERENCEResult Proceed to Fault is not listed in problem symptoms table A Fault is listed in problem symptoms table B B: Go to step 8
A: Go to Next Step
- OVERALL ANALYSIS AND TROUBLESHOOTING
- REPAIR OR REPLACE
- CONFIRMATION TEST
NEXT: END